Epson Expression Home XP-5200 Series

Example of Windows 10
Related Information
& “Rear” on page 17
Setting a Static IP Address for the Printer
is section describes how to make settings from the printer's control panel.
1.
Select Settings on the printer's home screen.
2.
Select Network Settings > Advanced > TCP/IP.
3.
Select Obtain IP Address, and then select Manual.
4.
Enter the IP address.
Focus moves to the forward segment or the back segment separated by a period if you select
l and r .
Conrm
the value
reected
on the previous screen.
5.
Set up the Subnet Mask and Default Gateway.
Conrm
the value
reected
on the previous screen.
c
Important:
If the combination of the IP Address, Subnet Mask and Default Gateway is incorrect, you cannot proceed with
the settings. Conrm that there is no error in the entry.
6.
Enter the IP address for the primary DNS server.
Conrm the value reected on the previous screen.
Note:
When you select Auto for the IP address assignment settings, you can select the DNS server settings from Manual or
Auto. If you cannot obtain the DNS server address automatically, select Manual and enter the DNS server address.
en, enter the secondary DNS server address directly. If you select Auto, go to step 8.
7.
Enter the IP address for the secondary DNS server.
Conrm
the value
reected
on the previous screen.
8.
Select Start Setup.
In These Situations > Adding or Changing the Printer's Connection > Setting a Static IP Address for the Printer
103