5.
Moisten a cotton swab with the water with a few drops of detergent so that it is not dripping water, and then
wipe the smeared part.
Be careful not to touch the ink that has adhered inside the printer.
c
Important:
Wipe o the smear gently. If you press the cotton swab too hard to the lm, the springs of the lm may be
dislocated and the printer may be damaged.
6.
Use a new dry cotton swab to wipe the lm.
c
Important:
Do not leave any bers on the lm.
Note:
To prevent the smear from spreading, frequently replace the cotton swab with a new one.
7.
Repeat steps 5 and 6 until the lm is not smeared.
8.
Visually check that the lm is not smeared.
9.
Close the scanner unit.
Maintaining the Printer
>
Improving Print, Copy, and Scan Quality
>
Cleaning the Translucent Film
79
To Next Page
Loading...
