4. Moisten a cotton swab with the water with a few drops of detergent so that it is not dripping water, and then
wipe the smeared part.
c
Important:
Wipe o the smear gently. If you press the cotton swab too hard to the lm, the springs of the lm may be
dislocated and the printer may be damaged.
5. Use a new dry cotton swab to wipe the lm.
c
Important:
Do not leave any bers on the lm.
Note:
To prevent the smear from spreading, frequently replace the cotton swab with a new one.
6. Repeat steps 4 and 5 until the lm is not smeared.
7. Visually check that the lm is not smeared.
Saving Power
e printer enters sleep mode or turns o automatically if no operations are performed for a set period. You can
adjust the time before power management is applied. Any increase will aect the product's energy eciency. Please
consider the environment before making any change.
Depending on the location of purchase, the printer may have a feature that turns it
o
automatically if it is not
connected to the network for 30 minutes.
Saving Power - Control Panel
1. Tap Settings on the home screen.
2. Tap Basic Settings.
User's Guide
Maintaining the Printer
181
To Next Page
Loading...
