Epson LX-810 User Manual

Printing
Problem
Solution
The number of lines
printed does not
match the length of
the paper.
Regular gaps occur
in the printout.
Skip over perforation
is set, but the
perforation does not
fall in the center of
the skip.
The page length may be set incorrectly.
Change the page length setting with DIP
switch 2-1. Refer to 3-9. If your program
allows you to send control codes to the
printer, specify page size by sending
ESC C or BSC C 0. If this does not resolve
the problem, check the page length set by
your application software and adjust it if
necessary.
If you are using the cut sheet feeder, the
self test function prints the number of
printable lines that can fit on a single
sheet. Use this feature to determine the
correct page length setting. Refer to 5-9.
One inch skip over perforation may be set.
Set DIP switch 2-3 to OFF. If your
program allows you to use control codes,
use ESC O to cancel skip over perforation.
Refer to 3-10.
The page length for continuous paper may
be set incorrectly. Make sure the setting of
DIP switch 2-1 matches your paper length.
Refer to 3-9. If your program allows you
to use control codes, you can also use
ESC C or ESC C 0 command to set the
page length. Refer to 9-13.
Troubleshooting 7-11

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)