Epson LX-810 User Manual

Printing
Problem Solution
The printed position
is not what you
expected (continued).
One line of printing
has taken up two
lines.
.A.II the text is
printed on the same
line.
The text is printed
with an extra blank
line in between.
The margins may not be set correctly. If
your application program is capable of
sending control codes, set the left and
right margins using ESC1 or ESC Q. Refer
to 9-19.
In BASIC, enter either of the following
statements:
WIDTH LPRINT 255
or
WIDTH "LPTl:", 255
If the printer still does not print properly,
set the right margin to the maximum
setting using ESC Q.
A line feed signal is not being sent at the
end of each line. Set DIP switch 2-4 to
ON so that the printer automatically adds
a line feed code to each carriage return.
Refer to 3-8.
Two line feed signals are being sent. Set
DIP switch 2-4 to OFF.
7-10 Troubleshooting

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)