Epson LX-810

Printing
Problem
Solution
The font selected by
SelecType is not
printed.
The print position is
not what you
expected.
Printing starts too
high or too low on
the page.
Line spacing is
incorrect.
The software may not be properly
installed for your printer. Use the
program's setup (or install) procedure to
check the printer settings and reset as
needed.
Your software may be overriding your
SelecType setting. If your program allows
you to change the printing style, software
control will override the SelecType
settings. Make sure that the printing
commands used in the software are
correct, then try printing again.
The loading position may be incorrect. Use
micro-adjustment to adjust the loading
position. Refer to 3-12. If the problem
persists, check the top margin set by your
application software and adjust it.
Line spacing is too tight or too far apart. If
your application program is capable of
sending control codes, specify the line
spacing using ESC 0, ESC 1, ESC 2, ESC 3
or ESC A. Refer to 9-15, 9-16.
T roubleshooting 7-9