Epson LX-810 User Manual

Printing
Problem
Solution
Printed characters
are not what you
expected (continued).
The wrong
international
characters are being
printed.
The characters
printed are smaller
than expected.
The wrong international character set is
selected. If your application program is
capable of sending control codes, specify
the desired international character set
using ESC R n. Refer to 9-31.
You can also select the international
character set by changing the DIP switch
setting. To do this, turn off the power and
set DIP switches 1-6, 1-7 and 1-8 to the
correct positions for the character set you
want. Refer to 3-23.
The condensed mode may be set. Set the
printer on line and press the CONDENSED
button once or twice to cancel the mode.
The beeper sounds twice to indicate that
the condensed mode is canceled. Refer to
3-19.
If your application program is capable of
sending control codes, you can cancel the
condensed mode by sending the DC2 code
to the printer. Refer to 9-24.
7-8 Troubleshooting

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)