Epson LX-810 User Manual

Printing
Problem
Solution
77z^ Roman, Sans
Serif or draft font is
selected in your
software, but the
characters are
printed in a
different font.
Italic characters are
printed instead of
the selected graphic
''line" characters.
Graphic characters
or lines are being
printed instead of
the selected italic
characters.
The wrong font is selected. If your
program accepts control codes, set the
codes to the values below to select the
fonts:
Roman: ESC
k 0
Sans Serif:
ESC k 1
Draft:
ESC
X 0
Refer to 3-19, 9-22.
The wrong character table is selected . If
your application program is capable of
sending control codes, specify the Epson
Extended Graphics character table using
ESC t 1. Refer to 9-31.
You can also select the graphics character
table by changing a DIP switch setting. To
do this, turn off the power, set DIP switch
1-3 to ON, then turn on the power. Refer
to 3-25.
The wrong character table is selected. If
your application program is capable of
sending control codes, specify the italic
character table using ESC t 0. Refer to
9-31.
You can also select the italic character
table by changing a DIP switch setting. To
do this, turn off the power, set DIP switch
1-3 to OFF, then turn on the power. Refer
to 3-25.
Troubleshooting 7-7

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)