Epson LX-810

Paper Handling
Problem Solution
/S^f\
The position of your paper supply may be
preventing it from feeding straight. Refer
to 2-7.
The paper may be caught on the edge
guides. When using continuous paper,
make sure that the paper guide is installed
over the paper and that the edge guides
are positioned at the center of the paper's
width. Refer to 2-13.
The holes on the sides of the paper may
not be aligned with each other. Reposition
the paper on the tractor pins. Refer to
2-11.
The sprocket units are incorrectly
positioned for the paper width. Move the
right sprocket unit to remove any slack
across the width of the paper. Refer to
2-12.
The sprocket lock levers may be unlocked,
or the sprocket covers may be open.
Position the sprocket units to match the
width of your paper. Then lock them in
place by pressing the sprocket lock levers
away from you. Refer to 2-12.
The paper thickness lever may be in the
wrong position. For printing on ordinary
paper, always set the lever to position 2.
Refer to 2-22.
Troubleshooting 7-17