Epson LX-810 User Manual

Paper Handling
Problem
Solution
Continuous paper
does not feed
properly (continued).
Regular gaps occur
in the printout.
Skip over perforation
does not function.
Skip over perforation
is set, hut the
perforation does not
fall in the center of
the skip.
The paper dimensions may exceed the
specified limits. Use only paper sizes that
are within the specified range. Your
printer can print on continuous multi-part
forms consisting of 1 original and 2 copies.
Refer to 2-25, 8-4.
Skip over perforation may be interfering
with your application program settings. Set
DIP switch 2-3 to OFF. If your program
allows you to use control codes, you can
instead use ESC O to cancel skip over
perforation. Refer to 3-10, 9-14.
You may not have turned off the power
after setting DIP switch 2-3 to ON. To
make new DIP switch settings effective,
turn the power off, then on again. Refer to
3-6.
The page length for one page of
continuous paper may be set incorrectly.
Set DIP switch 2-1 or use control codes
ESC C or ESC C 0 to set the page length
correctly.
7-18 Troubleshooting

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)