Epson LX-810

Options
Problem
Solution
Using the pull tractor
with the push tractor,
continuous paper
does not feed
properly.
When the FORM
FEED or LINEFEED
button is pressed,
platen does not
rotate and paper
does not feed.
Paper feed is crooked
or the paper jams.
The printer may be on line. Before using
the control panel buttons to feed paper,
always put the printer off line (ON LINE
light is out.)
Something may be obstructing the paper
feed. Make sure that the paper can feed
smoothly into the printer.
The supply of paper may be too far from
the printer. Position the paper supply so
that it is no more than 3 feet (1 meter)
from the printer.
The paper may be caught on the edge
guides. When using continuous paper, make
sure that the paper guide is lowered over
the paper and that the edge guides are
positioned at the center of the paper's
width. Refer to 5-31.
The pull tractor and push tractor sprockets
are not aligned correctly. When using both
tractors, be sure that the sprockets on both
are positioned evenly.
Troubleshooting 7-27