Epson LX-810

Options
I, Problem
Solution
The position of the roll paper may be
wrong. The roll should be oriented so that
paper feeds from the bottom. Refer to 5-39.
The paper may be caught on the edge
guides. Make sure that the paper guide is
installed over the paper and that the edge
guides are positioned at the center of the
paper's width. Refer to 5-40.
The paper guide may be in the upright
position. Make sure that the paper guide is
in the lowered position so it can act as a
paper separator. Refer to 5-40.
The paper may be creased. Make sure the
leading edge of the roll paper has a clean,
straight edge. Refer to 5-38.
/??S?^
The roll paper may not meet the
specifications. Be sure to use only paper
sizes or weights that are within the
specified range. Refer to 8-5.
/S^
Troubleshooting 7-31