Epson LX-810 User Manual

Testing the Printer
3. Move the left edge guide so that it locks in place next to the
guide mark.
4.
Adjust the right edge guide to match the width of your paper.
Next, slide a sheet down between the edge guides until it
meets resistance.
r\
%
WARNING: Run the self test using paper wider than A4
{SVi inches or 210 mm) or letter size (SVz inches or 216
mm), to prevent the print head from printing directly
onto the platen.
rs
1-18 Setting Up the Printer

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)