113
Setting Options Description
Standby Mode Communication On
Communication Off
Enable this setting to allow
monitoring and control of the
projector over a network when
the projector is in standby mode
Indicators On
Off
Enables or disables the status
indicator lights on the projector
Trigger Out Off
Power
Anamorphic Wide
Power: outputs a DC 12V signal
at 200 mA maximum from the
Trigger Out port whenever the
projector is turned on (ideal for
motorized screens)
Anamorphic Wide: voltage is
only output from the Trigger Out
port when the Aspect setting is
set to Anamorphic Wide or
Horiz.Squeeze (ideal for
anamorphic lens kits and
mechanical screens that can
change their aspect ratio)
Inv Direction Button On
Off
Inverts the direction of the arrow
buttons on the control panel to
match the projector's installation
position
Reset Operation Settings — Reset all settings on the
Operation menu to their default
values
Parent topic: Adjusting the Menu Settings
Related references
Image Quality Settings - Image Menu
To Next Page
Loading...