Epson QB1000 - Monitoring and Controlling the Projector; Connecting to a Wired Network

38
Monitoring and Controlling the Projector
Follow the instructions in these sections to monitor and control the projector over a network.
Note: Your product does not support network projection.
Connecting to a Wired Network
Selecting Wired Network Settings
Controlling a Networked Projector Using a Web Browser
PJLink
ESC/VP21 Commands
Connecting to a Wired Network
To connect the projector to a wired local area network (LAN), use a 100Base-TX or 10Base-T network
cable. To ensure proper data transmission, use a Category 5 shielded cable or higher.
Note: Your product does not support network projection. The LAN port is only used to monitor and
control the projector over a network.
1. Connect one end of the network cable to your network hub, switch, or router.
2. Connect the other end of the cable to the projector's LAN port.
Parent topic: Monitoring and Controlling the Projector