Epson QB1000 - Projector Control Settings

41
• If you must set addresses manually, select Off as the DHCP setting. Enter the projector's IP
Address, Subnet Mask, and Gateway Address as needed.
Note: Use the displayed keypad to enter numbers. Press the arrow buttons on the remote control to
highlight numbers and press Enter to select them. Select OK when you are done.
10. Press Esc to return to the Wired LAN menu.
11. To prevent display of the IP address on the network information screen, select Off as the IP
Address Display setting.
12. Press Esc to return to the Network Settings menu.
13. Select Projector Control and press Enter. Choose from the available options.
14. When you finish selecting settings, return to the Network Settings screen. Select Set and follow the
on-screen instructions to save your settings and exit the menus.
Note: If the Web Control Password has not been set, a screen prompting you to set a password is
displayed. Follow the on-screen instructions to set the password.
Projector Control Settings
Parent topic: Monitoring and Controlling the Projector
Projector Control Settings
You can select the following settings for controlling the projector over a network.
Setting Options Description
Basic Control On
Off
Enable to monitor and control the
projector using Basic Control in
Epson Web Control
Remote Password -- Enter a password to access the
projector using Basic Control in
Epson Web Control. (The user
name is EPSONREMOTE. No
password is set by default.)
PJLink On
Off
Set to On to enable the PJLink
notification function