Epson QB1000 - Page 40

40
4. Select Network Settings and press Enter.
5. Select Projector Name to enter a name to identify the projector over the network
Note: Use the displayed keyboard to enter the name. Press the arrow buttons on the remote control
to highlight characters and press Enter to select them. Select OK when you are done.
6. If you want to access the projector over the network, select Web Control Password and set a
password.
Note: The user name is EPSONWEB and no password is set by default. If you do not set a Web
Control Password, you will not be able to access the projector via Epson Web Control.
7. Select Wired LAN and press Enter.
8. Select IP Settings and press Enter.
9. Select your IP Settings as necessary:
• If your network assigns addresses automatically, select On as the DHCP setting.