Epson QB1000 - Connecting to a Trigger out Port

32
2. Connect the other end of the cable to the HDMI2 (eARC/ARC) port on the rear of the projector.
3. Adjust any necessary settings on the connected A/V system or external speakers. See your device's
documentation for more information.
Parent topic: Connecting External Output Devices
Connecting to a Trigger Out Port
You can connect your projector to external devices such as motorized screens or a motorized
anamorphic lens that support a trigger signal. When active, a 12V (200mA maximum) signal is sent to
the connected device while the projector is powered on. See the link below for cable specifications.
Note: If you select Anamorphic Wide as the Trigger Out setting, voltage is only output from the
Trigger Out port when the Aspect setting is set to Anamorphic Wide or Horiz.Squeeze.
1. Connect a 3.5 mm mono or stereo mini-jack cable to the external device's trigger port. See your
device's documentation for details.