Epson QB1000 - Correcting Image Shape with Point Correction

59
6. Use the arrow buttons on the projector or remote control to select the corner of the image you want
to adjust. Then press Enter.
Note: To reset your adjustments, press and hold the Esc button for at least 2 seconds to display a
reset screen. Then select Yes.
7. Press the arrow buttons to adjust the image shape as necessary. Press Enter to return to the area
selection screen.
Note: If one of the directional arrows on the screen turns gray, you cannot adjust the shape any
further in that direction.
8. When you are finished, press Esc.
The Geometry Correction setting is now set to Quick Corner in the projector's Installation menu. If you
press the keystone adjustment buttons on the control panel, the area selection screen appears.
Parent topic: Image Shape
Correcting Image Shape with Point Correction
You can use the projector's Point Correction feature to fine-tune the image shape using points on a grid.
This is useful for adjusting overlapping areas in multiple projected images that do not line up correctly.
1. Turn on the projector and display an image.
2. Press the Menu button.