Epson QB1000 - Controlling a Networked Projector Using a Web Browser

42
Setting Options Description
PJLink Password Up 32 alphanumeric characters Enter a password for using the
PJLink protocol for projector
control
(do not use spaces or any
symbols besides @)
Notified IP Address Various IP addresses Enter the IP address to receive
the projector's operating status
when the PJLink notification
function is enabled. Enter the
addresses using 0 to 255 for
each address field.
Do not use these addresses:
127.x.x.x or 224.0.0.0 through
255.255.255.255 (where x is a
number from 0 to 255).
AMX Device Discovery On
Off
Set to On to allow AMX Device
Discovery to detect the projector
Control4 SDDP On
Off
Set to On to allow device
information to be acquired using
Control4 Simple Device
Discovery Protocol (SDDP)
Parent topic: Selecting Wired Network Settings
Controlling a Networked Projector Using a Web Browser
Once you have connected your projector to your network, you can select projector settings and control
projection using a compatible web browser. This lets you access the projector remotely.
Note: Make sure that the projector and your computer or device are on the same network and that you
have set a Web Control Password in the Network Settings menu or you cannot access the Web
Control screen.
Note: The web setup and control features support Microsoft Edge (Windows), Safari (Mac), and Chrome
(Android) on networks that do not use a proxy server for connection. You cannot select all of the
projector menu settings or control all projector functions using a web browser.