43
Note: If you set Standby Mode to Communication On, you can use a web browser to select settings
and control projection even if the projector is in standby mode.
1. Make sure the projector is turned on.
2. Start your web browser on a computer or device connected to the network.
3. Enter the projector's IP address into the browser's address box (if you are entering an IPv6 address,
wrap the address with [ and ]).
Note: You can find the projector's IP address by selecting Wired LAN Info. in the projector's
Network menu.
Note: You may need to log in to access some of the options on the Web Control screen. If you see a
log in window, enter your user name and password.
• For the Basic Control option, use EPSONREMOTE as the user name and enter the Remote
Password. No password is set by default.
• For all other options, use EPSONWEB as the user name and enter the Web Control Password.
No password is set by default.
• You can change the password in the projector's Network menu:
• Network > Network Settings > Projector Control > Basic Control > Remote Password
• Network > Network Settings > Web Control Password
To Next Page
Loading...