138
Power light Status light Laser light Temp light Status and solution
Flashing blue Varies Varies Flashing
orange
Projector is too hot
• Make sure that the vents and air
filter are not clogged with dust or
obstructed by nearby objects
• Clean or replace the air filter
• Make sure the environmental
temperature is not too hot
Off Flashing blue Off Orange Projector has overheated and turned
off; leave it turned off to cool down for
about five minutes. After the fan has
stopped, do the following:
• Make sure that the vents and air
filter are not clogged with dust or
obstructed by nearby objects
• Make sure the environmental
temperature is not too hot
• Clean or replace the air filter
• If operating the projector at high
altitude, turn on High Altitude
Mode
• If the problem persists, unplug the
projector and contact Epson for
help
Off Flashing blue Off Flashing
orange
A fan or sensor has a problem; turn
the projector off, unplug it, and
contact Epson for help
Flashing blue Varies Flashing
orange
Varies Laser warning; turn the projector off,
unplug it, and contact Epson for help
Off Flashing blue Orange Off Laser problem; turn the projector off,
unplug it, and contact Epson for help
Off Flashing blue Flashing
orange
Off Internal projector error; turn the
projector off, unplug it, and contact
Epson for help
To Next Page
Loading...