Epson SC-R5000 Series User Manual

R
S
Hold the center of the media with one hand,
and pull it straight out until the leading edge of
the media enters the entrance of the curing
heater.
c
Important:
If the leading edge of the media is wavy or
deformed by the heat, pull it all the way out
of the front of the pressure rollers. If the
pressure rollers press down on wavy or
deformed areas, printing will not be
performed correctly.
Do not pull the media with both hands. This
could cause the media to skew or move around.
T
U
Tap lightly on both ends of the media, and
check if there is a difference in tension between
the left and right sides.
If there is a difference in tension, the media
becomes loose.
From the front of the printer, move the media
loading lever to the back, and correct any
looseness in the media.
Once the looseness is corrected, move the
media loading lever to the front.
SC-R5000 Series/SC-R5000L Series User's Guide
Basic Operations
52

Epson SC-R5000 Series Specifications

General

Brand	Epson
Model	SC-R5000 Series
Category	Printer
Language	English