36
2
Set the suction area according to the size of the media being printed and the loading
position.
2-1 Press the Vacuum button to turn off the suction system.
2-2 Open the valve according to the position in which the media is loaded. The media sticks to the table.
Cover any suction holes in the suction area that are not covered by the media with a
sheet and so on. If these suction holes are not covered, the suction power will be
significantly reduced.
Cover the suction holes with media that is thinner than the media being printed. Also,
do not use mirrors, glass, or shiny metal plates. UV light reflected by materials such as
these can cure the ink around the print head causing a malfunction to occur.
To Next Page
Loading...
