44
Make sure the closed valves look approximately as shown in the illustration. If the valves are not fully
closed, ink may leak while the printer is off, causing the nozzles to become clogged when the printer is
used again.
7
Return the louver (flushing box) on the ink receiver to the front position.
8
Turn the switch on the front of the printer to turn off the printer.
9
Close the UV Flatbed Controller on the computer.
• Ink temperature controller
Make sure the display on the left side of the controller is 30°C or higher.
6-3 Close the carriage cover.
To Next Page
Loading...
Need help?
General
