99
When Problems Occur
When data for varnish printing is created using spot color settings in image processing
software
Open the print data in image processing software such as Adobe Illustrator, and then set the density of the spot color
name "Varnish" to 100% to create the print data. Add the created print data to the job list in Epson Edge Print, and
then print again.
Example: When using Adobe Illustrator
If there is no improvement, use Epson Edge Print to create and print two jobs: a color layer and a varnish layer.
N"Printing the Color Layer and Varnish Layer Separately" on page 100
When data for varnish printing is created using Epson Edge Print's auto layer creation
method
Use Epson Edge Print to create and print two jobs: a color layer and a varnish layer.
N"Printing the Color Layer and Varnish Layer Separately" on page 100
If the solutions above do not improve the issue
Use Epson Edge Print to create and print a multi-layered print job for the color layer and the varnish layer using the
white layer as the base layer for both.
N"Printing Using a White Layer as the Base Layer" on page 104
To Next Page
Loading...
