EPSON Stylus Photo 925 Revision A
Disassembly and Assembly Disassembly 107
T Make certain that all the gears have been installed on the shaft of
the Ink System Frame, and rotate the combination gear 9.6, 24 to
check for smooth motion of the CR Lock Lever.
Figure 4-71. Checking for mounting of Gears on the Ink System
Frame
T Tightening torque for screws
• One screws securing the Ink System Tray:
C.B.S. SCREW, 3x6, F/ZN : 4 ~ 6kgf.cm
• Five screws securing the Ink System Frame:
C.B.S. SCREW, 3x4, F/UC : 6 ~ 8kgf.cm
C.B.S. SCREW, 3x6, F/ZN : 6 ~ 8kgf.cm
(C.B.S. SCREW, 3x6, F/ZN which secure the Cap Unit and Cutter
Unit: 8 ~ 10kgf.cm)
A D J U S T M E N T
R E Q U I R E D
T Once the combination gear 9.6, 24 has been removed or when it
has been replaced with a new one, be sure to apply an
appropriate amount of grease G-26 to the specified points.
(Refer to Figure 6-9. “Lubrication point 8” in Chapter 6.)
Combination Gear 37.6, 44.4
Combination Gear 14.4, 38.4
CR Lock Lever
Combination Gear 9.6, 24
Spur Gear 27.2
To Next Page
Loading...
