Epson Stylus Photo 925 - EEPROM Initialization

EPSON Stylus Photo 925 Revision A
Adjustment Adjustment Program 123
Figure 5-4. Main Menu
This adjustment program includes the following buttons.
V End
Click on the [Quit] button to display the menu shown below. Adjustments will be
completed and the program ended when the [Quit] button is clicked. The screen
will return to the model selection screen when the [Next] button is clicked.
Figure 5-5. Termination
5.3.3 EEPROM initialization
It is required to write the initial setting values into EEPROM when the Main Board is
replaced.
Figure 5-6. EEPROM initialization
Click the [OK] button, and the intended market will be written in EEPROM.
Figure 5-7. Intended Market Setting Completion Screen
C A U T I O N
T Do not start up the adjustment program before connecting the
USB cable to the printer.
T Be sure to restart the adjustment program if the printer power is
turned off or the USB cable is disconnected during the
adjustment program execution.