Epson Stylus Photo 925 - First Dot Position Adjustment; Cut Position Adjustment

EPSON Stylus Photo 925 Revision A
Adjustment Adjustment Program 129
5.3.8 First Dot Position Adjustment
With this function, you can adjust the first dot position. This adjustment is not
necessary for repair, as a rule. However, make this adjustment on user's request.
In adjustment, specify “+” to shift the first dot position to the left or “-” to shift it to the
right.
Figure 5-21. First dot position adjustment
5.3.9 Cut Position Adjustment
With this function, you can adjust the cut position.
Make sure the the check pattern is printed on the roll paper before you enter the
adjustment value.
Adjust by the order below:
Checking by the check pattern → Adjustment → Printing → Checking.
Figure 5-22. Cut position adjustment