Epson Stylus Photo 925 - Housing Lower Cover Right Rear and Front Removal

EPSON Stylus Photo 925 Revision A
Disassembly and Assembly Disassembly 83
4.2.3.2 Housing Lower Cover Right Rear and Front removal
1. Remove the Housing from the printer. (Refer to 4.2.1 “Housing removal”)
2. Remove the two screws (C.B.S SCREW, 3x6, F/ZN and C.B.P-TITE SCREW,
3x8, F/ZN) securing the Housing Lower Cover Right Rear and remove the
Housing Lower Cover Right Rear.
Figure 4-13. Removing the Housing Lower Cover Right Rear
T Tightening torque for screws
• Five screws securing the Housing Lower Cover Left Rear/Front:
C.B.P-TITE SCREW, 3x8, F/ZN : 5 ~ 7kgf.cm
C.B.S SCREW, 3x6, F/ZN : 5 ~ 7kgf.cm
A D J U S T M E N T
R E Q U I R E D
T Once the combination gear 47, 19.2 has been removed or when it
has been replaced with a new one, be sure to apply an
appropriate amount of grease G-26 to the gear shaft.
(Refer to Figure 6-11. “Lubrication point 10” in Chapter 6.)
Housing Lower Cover Right Rear
C.B.S SCREW, 3x6, F/ZN
C.B.P-TITE SCREW, 3x8, F/ZN