Epson Stylus Photo 925 - PE Sensor Removal

EPSON Stylus Photo 925 Revision A
Disassembly and Assembly Disassembly 94
4.2.8 PE Sensor removal
1. Remove the Housing from the printer. (Refer to 4.2.1 “Housing removal”)
2. Remove the LD Roller Shaft Holder from the printer body, and remove the LD
Roller.
(Refer to 4.2.7 “LD Roller removal”)
3. Disengage the hooks of the PE Sensor fastened to the LD Roller Shaft Holder and
take out the PE Sensor.
Figure 4-40. Removing the PE Sensor
Hooks
PE Sensor
C H E C K
P O I N T
T Make sure that the Torsion spring 0.22 is hung to the following
suitable position.
Figure 4-41. Checking the setting of Torsion Spring
Torsion Spring 0.22