EPSON Stylus Photo 925 Revision A
Disassembly and Assembly Disassembly 80
4. Remove the four screws (C.B.P-TITE SCREW, 3x8, F/ZN) securing the Housing
Cover and remove the Housing Cover.
Figure 4-5. Removing the Housing Cover
Figure 4-6. Checking for LCD Grounding Plate
T When installing the Housing, connect the Panel FFC to the Main
Board securely.
T When installing the Housing, make sure that the LCD
Grounding Plate has been installed on the Main Frame.
C.B.P-TITE SCREW, 3x8, F/ZN
LCD Grounding Plate
T Tightening torque for screws
• Two screws in the front of housing:
C.B.S TITE-R SCREW, 3x6, F/UC: 5 ~ 7 kgf.cm
• Three screws at the rear of housing:
C.B.S SCREW, 3x6, F/ZN: 5 ~ 7 kgf.cm
• Four screws securing the housing cover:
C.B.P-TITE SCREW, 3x8, F/ZN: 5 ~ 7kgf.cm
T When installing the Stacker Supplement on the Cutter Cover,
make certain that the Torsion Spring 2.03 has been set properly
on the Stacker Supplement and the Stacker Supplement Arm.
Figure 4-7. Installation of Stacker Supplement
Torsion Spring 2.03
Stacker Supplement
Arm
Cutter Cover
Stacker Supplement
To Next Page
Loading...
