162 Printing with Mac OS 8.6 to 9.x
2. Choose Auto Expand or Retain Size from the pull-down
menu next to the Borderless check box.
3. Make the Auto Cut setting. See “Making the Auto Cut setting”
on page 162.
4. Click OK.
5. Start printing your data from your application.
Making the Auto Cut setting
You can select the following cutting methods. This function is
available only when Roll Paper or Roll Paper (Banner) is selected
as the Paper Source.
Auto
Expand
Select this setting if you want to enlarge the size of print
data automatically and print with no margins.
Note:
Enlarged areas that exceed the paper size will not be
printed on the paper.
Retain Size Select this setting if you do not want to change the ratio
of your print data.
If you select this setting, you need to enlarge your
image data to exceed the paper width, to avoid
unprinted areas appearing along the left and right
edges. Enlarging 3mm in both the left and right
directions is recommended, using the application with
which you made data.
If you do so, see “Making the Paper Sizes setting” on
page 158.
To Next Page
Loading...
