The Control Panel 23
1
1
1
1
1
1
1
1
1
1
1
1
This operation changes according to the Auto Cut settings.
Note:
When the Sheet is selected as the paper source, this setting is not
available.
INTERFACE
You can select the interface that receives your print data. When
you select AUTO, the printer automatically switches between
interfaces depending on which one is receiving data first. When
you select USB, IEEE1394, or OPTION, only the selected interface
receives your print data. If no more print jobs have been received,
the printer returns to an idle state after 10 seconds or more.
CODE PAGE
You can select the code page from PC437 (extended graphics) and
PC850 (multilingual).
Paper Source Print Page Line Printer’s Operation
Roll Auto Cut On On Prints page line on the right
side only, and cuts paper
automatically after the print
job.
Roll Auto Cut On Off Does not print page lines, and
cuts paper automatically
after the print job.
Roll Auto Cut Off On Prints page lines on the right
side and below the data, but
does not cut paper
automatically after the print
job.
Roll Auto Cut Off Off Does not print page lines nor
cut.
To Next Page
Loading...
