30 The Control Panel
CUSTOM PAPER
This menu contains the following items.
PAPER NUMBER
When you select STD, the printer determines paper thickness
automatically. You can also select No. X (X can be any number
between 1 to 10) to register the following settings or to recall the
following settings you made.
Note:
If you select STANDARD, the printer prints data according to the driver
settings. If you select No. X, the control panel settings override the
driver settings unless you select AUTO in THICKNESS NUM.
PLATEN GAP
You can adjust the distance between the print head and paper.
Normally, leave this set to STANDARD. If you find that the printed
image is smeared, select WIDE. Select NARROW for printing on a thin
paper. Select WIDER for printing on a thick paper.
THICKNESS PAT
You can print the paper thickness detection pattern. If you select
STANDARD in PAPER NUMBER, the pattern is not printed.
❏ Platen gap
❏ Thickness pattern
❏ Thickness number
❏ Cut method
❏ Paper feed adjustment
❏ Eject roller type
❏ Drying time
❏ Suction
❏ MicroWeave adjustment
To Next Page
Loading...
