Epson STYLUS PRO 4910 - Page 425

Epson Stylus Pro 4900/Epson Stylus Pro 4910 Revision A
MAINTENANCE Lubrication 426
Confidential
[Lubrication 3] [Lubrication 4]
Part Name HOLDER, SENSOR, RELEASE, ASF UNIT
Lubrication Point
A: On the portion where it contacts with SPUR GEAR, 76.8,
RIGHT
B: On the portion where it contacts with HOLDER, SENSOR,
RELEASE, ASF
Lubricants (Part Code) Grease G-71 (1304682)
Amount φ 2 x 3 mm x 2 points
Lubrication Tool φ 2 mm injector
Lubrication Manner Apply the specified amount with an injector.
Note
After lubricating, spread the lubricant evenly by rolling SPUR
GEAR.
Lubrication Point A
Lubrication Point B
Part Name SHAFT, RELEASE, PAPER GUIDE, UPPER UNIT
Lubrication Point
A: On the portion where it contacts with MOUNTING PLATE,
ASSEMBLY, RELEASE, DRIVEN, LEFT
B: The shaft engaged with FRAME, MAIN
C: Cogs of SPUR GEAR, 22
Lubricants (Part Code) Grease G-26 (1080614)
Amount
A, B: φ 2 x once around x 2 portions
C: φ 2 x 2 mm x 1 portion
Lubrication Tool φ 2 mm injector
Lubrication Manner Apply the specified amount with an injector.
Note ---
Lubrication Point C
Lubrication Point A
Lubrication Point B