Epson STYLUS PRO 4910 - Page 428

Epson Stylus Pro 4900/Epson Stylus Pro 4910 Revision A
MAINTENANCE Lubrication 429
Confidential
[Lubrication 7-3] [Lubrication 7-4]
Part Name CR Unit
Lubrication Point Inside HOLDER, OIL PAD
Lubricants (Part Code) Grease G-84 (1516265)
Amount 0.3cc x 2 points
Lubrication Tool φ 4 mm injector
Lubrication Manner
Detach HOLDER, OIL PAD. (p181)
Apply lubricant so as to fill in the bands inside HOLDER, OIL
PAD
Note ---
Lubrication Point
CR Unit
Part Name CR Unit
Lubrication Point On the portion where it contacts with GUIDE BOARD, CR
Lubricants (Part Code) Grease G-84 (1516265)
Amount φ 2 x 6 mm x 1 point
Lubrication Tool φ 2 mm injector
Lubrication Manner
Apply the specified amount with an injector.
Slide in CR unit to SHAFT, CR. Apply lubricant grease to the dent
of SLIDER, CR just before SLIDER, CR goes into GUIDE
BOARD, CR.
Note ---
Lubrication Point