Printable area
The gray area in the illustration below shows the printable area. The arrow indicates the feed direction.
*
When Paper Size Check is set to Off, this is 1,118 mm (44 inches) regardless of the width of the loaded paper.
A to D indicates the margins on all four sides. See the following for more details.
Margin Position Explanation Available
Setting
Range
A Rear
*1
This can be set in RIP. To maintain paper feeding accuracy, if the setting is less than 5
mm, it switches to 5 mm.
5 mm or more
B Leading edge
*1
This can be set in RIP. This differs depending on the length of paper pulled out when
the paper is loaded. Margins set in RIP are added during continuous printing, but to
maintain paper feeding accuracy, if the setting is less than 5 mm, it switches to 5 mm.
5 mm or more
C Left edge
*2, *3
The value set for Side in Roll Paper Margin from the printer's setup menu. The default
setting is 3 mm.
3 mm or 15 mm
D Right edge
*2, *3
*1 The set margin and the actual print results may differ depending on the RIP being used. Contact the RIP
manufacturer for more information.
SC-F6300 Series User's Guide
Basic Operations
43
To Next Page
Loading...
