Epson SureColor SC-F6300 Series - Setup Menu

Item Parameter Explanation
Nozzle Check Press the Z button to print a nozzle check pattern. Inspect the
pattern visually and perform head cleaning if you detect faint or
missing colors.
U “Clearing clogged nozzles” on page 81
Head Cleaning
All Nozzles Execute (Light) Note the numbers of patterns that contain faint or missing colors
and clean all or selected nozzles. Perform cleaning using All Nozzles
if there are faint or missing areas in all of the lines. Perform cleaning
using Selected Nozzles if there are faint or missing areas in specific
lines. You can select multiple lines in Selected Nozzles.
U “Clearing clogged nozzles” on page 81
Execute
(Medium)
Execute (Heavy)
Selected Nozzles Execute (Light)
Execute
(Medium)
Execute (Heavy)
Cutter Maintenance
Adjust Cut Position
-3 to 3 mm (0
*
)
The cut position can be adjusted in increments of 0.1 mm.
Replace Cutter Moves the cutter to the replacement position so it can be replaced.
Press the Z button to move the cutter to the replacement position.
The paper must be removed before the cutter can be replaced.
Remove the paper before proceeding.
U “Replacing the Cutter” on page 87
Head Maintenance Yes Cleans the print head. You need the Head Maintenance Kit to
execute this option. See the following for more details.
U “Print Head Maintenance” on page 85
No
Head Cap Cleaning When you press the Z button, the print head moves to the cleaning
position and the caps can be cleaned. See the following for more
information on cleaning.
U “Cleaning Caps” on page 67
Waste Ink Counter If you replace the Waste Ink Bottle before being prompted by a
message indicating the replacement interval of the Waste Ink Bottle
in the control panel, run the Waste Ink Counter option after
replacement.
Setup menu
* indicates default settings.
Item Parameter Explanation
Printer Setup
SC-F6300 Series User's Guide
Using the Control Panel Menu
54