c
Important:
If you replace the Waste Ink Bottle before being
prompted by a message, always clear the waste ink
counter. Otherwise, Waste Ink Bottle replacement
time will not be notified correctly from the next
message.
Replacing the Waste Ink Bottle
Follow the procedure below to replace the parts.
Before starting this procedure, be sure to read the
following:
U “Precautions Regarding Maintenance” on page 65
A
Remove the Waste Ink Bottle from the Waste Ink
Bottle holder.
If the back of the stopper is stained, wipe it.
B
Insert the waste ink tube into the mouth of the
new Waste Ink Bottle and place the Waste Ink
Bottle in the holder.
Tightly seal the lid on the used Waste Ink Bottle.
c
Important:
❏ Be sure to confirm that the waste ink tube
is inserted in the mouth of the waste ink
bottle. Ink will spill onto the surrounding
area if the tube is not inserted in the bottle.
❏ You will need the lid for the Waste Ink
Bottle when disposing of waste ink. Keep
the lid in a safe place; do not throw it out.
C
Lower the stopper.
c
Important:
Check that the stopper is stuck close to the
mouth of the bottle. If there is a gap, waste ink
may splatter and stain the surrounding area.
D
Press the Zbutton.
E
Check again to confirm that a new Waste Ink
Bottle is correctly installed. Press the Z button
to clear the waste ink counter.
U “Handling Used Consumables” on
page 89
SC-F6300 Series User's Guide
Maintenance
80
To Next Page
Loading...
