E
Confirm that the paper is not loose.
Check for any differences in tension on the right
and left by lightly tapping on both edges of the
paper.
c
Important:
If there are differences in tension on the left
and right, the paper cannot be wound
correctly. If there is slack on one side, flip the
Manual switch to Backward to rewind the
paper, peel off the tape, and then restart from
Step 1.
Removing Paper from the Auto
Take-up Reel Unit
This section describes how to remove paper from the
auto take-up reel unit.
Caution:
Removing paper from the auto take-up reel unit
requires two workers, one on each end of the roll.
A single worker working alone could drop the roll,
resulting in injury.
Buttons that are used in the following settings
A
Set the Auto switch to Off.
B
Cut the paper and take it up until it is all on the
auto take-up reel unit roll core.
U “Manual cut method” on page 26
After cutting the paper, support the end to
prevent the printed surface from touching the
floor; continue to support the paper until it is all
taken up. Hold down the Manual switch in the
take-up direction (either Forward or Backward).
SC-F6300 Series User's Guide
Basic Operations
41
To Next Page
Loading...
Need help?
General