H
Follow the instructions on the control panel
screen to open the printer cover and remove the
two cleaning pads.
c
Important:
❏ Remove them carefully so that no dirt gets
on the surrounding area.
❏ Check the platen and clean it if it is dusty
or dirty.
U “Cleaning the platen” on page 72
Do not reuse the cleaning pads.
U “Handling Used Consumables” on
page 89
I
Close the printer cover, and then press the Z
button.
Head cleaning starts. When the procedure is
complete, head cleaning is finished.
Replacing the Cutter
Replace the cutter when it is not cutting paper cleanly.
Supported cutter
U “Options and Consumable Products” on
page 99
Use a cross-head screwdriver to replace the cutter. Make
sure you have a cross-head screwdriver with you before
replacing the cutter.
c
Important:
❏ Take care not to damage the cutter blade.
Dropping it or knocking it against hard objects
may chip the blade.
❏ The sheets between the new cutters are to
protect the blades.
Do not remove the sheet while replacing the
cutter.
Read the following before starting this procedure.
U “Precautions Regarding Maintenance” on page 65
Buttons that are used in the following settings
A
Confirm that the printer is ready to print. Use the
l/r buttons to select -, and then press the Z
button.
The Maintenance menu is displayed.
B
Use the d/u buttons to select Cutter
Maintenance, and then press the Z button.
C
Use the d/u buttons to highlight Replace Cutter
and press the Z button.
D
The cutter will move to the replacement position.
E
Remove the old cutter from the printer.
Loosen the screw holding the cutter in place
using a cross-head screwdriver and pull the
cutter straight out.
Caution:
Do not store the cutter within the reach of
children. The cutter's blade could cause an
injury. Pay careful attention when replacing
the cutter.
SC-F6300 Series User's Guide
Maintenance
87
To Next Page
Loading...
