F
Install the new cutter.
Insert the cutter so that the pin on the printer
matches up with the hole on the cutter. Use a
cross-head screwdriver to tighten down the
screw to hold the cutter in place.
c
Important:
Tighten the screws firmly. If the cutter is not
securely fastened, the cutting position may
shift or be at the wrong angle.
G
After replacing the cutter, press the Z button.
The cutter will return to its original position.
The protective sheet is automatically removed
from the cutter section.
Ready is displayed in the control panel when the
process is complete.
SC-F6300 Series User's Guide
Maintenance
88
To Next Page
Loading...
