I
Move the lock lever on the left-side roll core
holder to the lock position to secure the roll core
holder.
Attaching the Paper
The procedure varies with the take-up direction.
c
Important:
Before proceeding, select Off as the Auto Cut
setting. Using the auto take-up reel unit when On is
selected will cause errors.
U “Cutting the roll paper” on page 26
When taking-up with the "printed
side in"
Buttons that are used in the following settings
A
Tape the leading edge to the roll core.
In the order shown in the illustration below, use
commercially available tape to tape the paper.
When attaching in the center, attach using tape
while pulling the center of the paper straight.
When attaching using the left and right sides,
attach using tape while pulling the paper to the
side.
B
Press the d button on the control panel until you
have fed enough paper for about one full wrap
around the roll core.
SC-F6300 Series User's Guide
Basic Operations
38
To Next Page
Loading...
