G
Remove the wiper.
Holding the wiper by the attachment point, tilt it
left and lift it out.
H
Insert new wiper.
Remove the cap on the wiping part of the wiper.
Place on the attachment point and press down
until you hear a click.
I
After replacing, close the maintenance cover,
and then press the Z button twice.
Disposal of used wipers and wiper cleaners
U “Handling Used Consumables” on page 89
Print Head Maintenance
If ink continues to drip onto the print results even after
performing head cleaning several times, use the Head
Maintenance Kit to clean the print head.
Prepare the following items before beginning.
Read the following before starting this procedure.
U “Precautions Regarding Maintenance” on page 65
Buttons that are used in the following settings
A
Confirm that the printer is ready to print. Use the
l/r buttons to select -, and then press the Z
button.
The Maintenance menu is displayed.
B
Use the d/u buttons to select Head
Maintenance and press the Z button.
C
When the message Prepare head maintenance
kit.Continue? is displayed, select Yes, and then
press the Z button.
The print head moves.
D
Remove the backing from the two cleaning pads.
SC-F6300 Series User's Guide
Maintenance
85
To Next Page
Loading...
