Epson TM-C7500 Series

127
Chapter 3 Handling
3
Code93
•A start code, 2 check digits, stop code is automatically added.
•A character () that indicates a start code is printed for the head of the HRI character.
•A character () that indicates a stop code is printed for the end of the HRI character.
•HRI characters of the control characters (00h ~ 1Fh, 7Fh) are printed combining ‘■’ and an
alphabetical character.
Code128
•Only when the automatic conversion is OFF, the start code is added on 2 digits at the front. When
"Auto Convert to Minimize Entire Symbol Width" is enabled, a code selection character is selected
automatically so that the entire width of the symbol becomes at minimum. Therefore, it is
not
necessary to specify a code selection character from an application.
 While the code selection character CODE A is selected, if {A is specified to select CODE A, an error
occurs.
 While the code selection character CODE B is selected, if {B is specified to select CODE B, an error
occurs.
 While the code selection character CODE C is selected, if one of the following is specified, an error
occurs.
Control
Character
HRI
Character
Control
Character
HRI
Character
Control
Character
HRI
Character
ASCII
Hexa-
decimal
ASCII
Hexa-
decimal
ASCII
Hexa-
decimal
NULL 00 ■UVT0B ■KSYN16 ■V
COH 01
■AFF0C ■LETB17 ■W
STX 02
■BCR0D ■MCAN18 ■X
ETX 03
■CSO0E ■NEM19 ■Y
EOT 04
■DSI0F ■OSUB1A ■Z
ENQ 05
■EDLE10 ■PESC1B ■A
ACK 06
■FDC111 ■QFS1C ■B
BEL 07
■GDC212 ■RGS1D ■C
BS 08
■HDC313 ■SRS1E ■D
HT 09
■IDC414 ■TUS1F ■E
LF 0A
■J NAK 15 ■UDEL7F ■F