178
6
If the settings are changed properly, the following window is displayed.
Click [Finish].
7
Turn off this product's power and turn it on again.
For Ethernet interface
Setting the IP Address
Set the IP address of this product.
For the setting method, see "Network settings" on page 67
.
Setting the printer resolution and monochrome print mode
Use the PrinterSetting to set the printer's resolution based on the resolution of the printer using ZPL
II commands. Also set your printer to monochrome print mode. For the setting method, see
"Replace settings from printer using ZPL II commands" on page 107.
Registering Preset Images
Use the PrinterSetting to register preset images.
Registering images
Set the images to be used in preset printing. See "Store data in the printer" on page 99.
Setting preset images
Set the preset images. For the setting method, see "Preset image" on page 101.
To Next Page
Loading...
