Epson TM-C7500 Series User Manual

133
Chapter 3 Handling
3
•GS1 DataBar
 Module: Sets the module width for GS1 DataBar.
"Recommended value of the module" on page 134 for the recommended
value.
 Number of Characters:
Sets the maximum width for GS1 DataBar.
Set when GS1 DataBar Expanded Stacked is selected for the 2D symbol.
•AztecCode
 Type: Select a mode for AztecCode.
 Cell Size: Select the width of cell (module) for AztecCode.
"Recommended value of the module" on page 134 for the recommended
value.
 Number of Layers: Select the number of layers for AztecCode.
[Minimize]: Optimize the minimum number of layers automatically.
[Specify the Size]: Change the number of layers specified by t he valu e in
the input box.
 Error Correction Area:
Specify the error correction area of AztecCode using of either the follow-
ing. The dat
a can be read even if the part of the symbol is broken, and res-
toration ratio becomes higher for bigger numbers.
[Auto]:Default value is 23%+3 code words.
[Specify a Percentage]: Specify the error correction area with a percentage
value in the input box.
•DataMatrix
 Symbol Shape: Set when "Rectangle" is selected for the sample shape of DataMatrix.
 Error Correction Level:
Select an error correction level for DataMatrix.
 Cell Size: Select the width of cell (module) for DataMatrix.
"Recommended value of the module" on page 134 for the recommended
value.
 Number of Vertical Cells:
Specify the number of cells for DataMatrix in the vertical direction.
Set when "Rectangle" is selected for the sample shape of DataMatrix.
 Number of Horizontal Cells:
Specify the number of cells for DataMatrix in the horizontal direction. Set
whe
n "Rectangle" is selected for the sample shape of DataMatrix.
[Minimize]: Optimize the minimum number of cells automatically.
[Specify the Size]: Change settings to the selected size.
3
Click [Add].
The selected 2D symbol font is saved and the font name is added to the font list.
 The 2D symbol font can be registered up to 30.
 The 2D symbol font setting can be overwritten by clicking [Save] after selecting the font
name from the font list and changing the setting.
 The 2D symbol font setting can be deleted by clicking [Delete] after selecting the font name
from the font list.

Epson TM-C7500 Series Specifications

General

Resolution	600 x 1200 dpi
Colours	Cyan, Magenta, Yellow, Black
Power Supply	Internal
Print Speed	Up to 300 mm/sec
Media Width	2" (50 mm) - 4.25" (108 mm)
Interface	USB, Ethernet
Weight	Approximately 37 kg
Print Width	4.09" (104 mm)
Media Types	Roll
Supply Voltage	AC 100-240V, 50/60 Hz
Media Thickness	0.08 to 0.2 mm