161
Chapter 3 Handling
3
PRINTER ERROR ##
(##: 01 to 0A, 16 to 18,
26, 27,2A, 31 to 37
41 to 47, 56 to 58, 62,
63, C1 to C4, C6 to C8,
D6 to DB)
Paper jam
Poor autocutter operation
Irregular ambient temperature
Malfunction
The printer will not recover until you perform
the proper processing, then turn the power
on again.
1. Turn the power off.
2. Open the paper set cover.
3.Open the front cover.
If you cannot open the front cover, the
cutter blade may be locked. Turn this
product's power off and on again.
4. Remove all the paper that is in the paper
path.
5. Close the front cover.
6. Turn the power back on.
(If the error occurs again, request a
repair.)
7. Run auto loading of the paper.
ERR B2 This error may occur if you run
[Paper feed adjustment (Mech
wear)] using PrinterSetting
when print data is left in the
product.
When this error occurs, turn the product off
and back on.
Also, when running [Paper feed adjustment
(Mech wear)] using PrinterSetting, make sure
the product is in "Ready" mode before
starting the operation.
SERVICE REQD. ##
(##: F0 to F4)
Service required
The product is beyond its
service life.
Malfunction
Request a repair.
LCD display
Error
Description Recovery method
To Next Page
Loading...
Need help?
General
