71
Chapter 5 Handling the Product
Handling the Product
This chapter describes the basic handling procedures for the product.
Turning On/Off
This section describes how to turn the product on/off.
Turning the Power On
Hold down the (POWER) button for at least 1 second until the (POWER) LED turns on.
Turning the Power Off
Hold down the (POWER) button for at least 3 second until the (POWER) LED turns off.
To turn off power without using the (POWER) button, send the command that executes the power off
sequence.
CAUTION
• Do not remove and insert the power plug from/to the outlet while the power of the product is in
the on state. Doing so may cause electric shock or fire.
• Turning off the product by performing a (POWER) button operation or by sending a com-
mand causes the ink head to be capped automatically to prevent the ink from drying. If you do
not plan to use the product after installing an ink cartridge, be sure to use either of the methods
above to turn off power. Do not pull out the power plug or turn off the breaker while the power
is on.
To Next Page
Loading...
